Reference Guide

mac access-group
Apply a MAC ACL to traffic entering or exiting an interface. You can apply a MAC ACL on a physical, port-
channel, or VLAN interface.
C9000 Series
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-
name command.
Parameters
access-list-name Enter the name of a configured MAC access list, up to 140
characters.
vlan vlan-range (OPTIONAL) Enter the keyword vlan and then enter a range
of VLANs. The range is from 1 to 4094 (you can use IDs 1 to
4094).
NOTE: This option is available only with the keywordin
option.
in Enter the keyword in to configure the ACL to filter
incoming traffic.
out Enter the keyword out to configure the ACL to filter
outgoing traffic.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
308
Access Control Lists (ACL)