Reference Guide

NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
permit — configures a MAC address filter to pass packets.
seq — configures a MAC address filter with a specified sequence number.
mac access-list extended
Configure an extended MAC access control list (extended MAC ACL).
C9000 Series
Syntax
mac access-list extended access-list-name [cpu-qos]
To delete a MAC access list, use the no mac access-list extended access-
list-name [cpu-qos] command.
Parameters
access-list-name Enter a text string as the MAC access list name, up to 140
characters.
cpu-qos Enter the keyword cpu-qos to configure an extended MAC
ACL to be used only to filter protocol traffic for control-
plane policing (CoPP).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
322
Access Control Lists (ACL)