Reference Guide

set metric
To assign a new metric to redistributed routes, configure a filter.
C9000 Series
Syntax
set metric [+ | -] metric-value
To delete a setting, enter no set metric.
Parameters
+ (OPTIONAL) Enter + to add a metric-value to the
redistributed routes.
- (OPTIONAL) Enter - to subtract a metric-value from the
redistributed routes.
metric-value Enter a number as the new metric value. The range is from
zero (0) to 4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric-type — specifies the route type assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
358
Access Control Lists (ACL)