Reference Guide

in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound
updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
C9000 Series
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
debug BGP information corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol
operations corresponding to either a default or non-
default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal
format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
Border Gateway Protocol
419