Reference Guide

define Interface range macro
definition
dot1x Configure 802.1x
ecmp-group ECMP group configuration
enable Modify enable password
parameters
end Exit from configuration mode
ethernet Ethernet options
exit Exit from configuration mode
fastpatch Process runtime patch
fefd-global Enable FEFD globally
ftp-server FTP configuration subcommands
garp Configure GARP parameters
hash-algorithm Hash algorithm command
hg-link-bundle-monitor Configure HiGig Link Bundle
Monitoring
hostname Set system's network name
http-server Configure the HTTP server
interface Select an interface to
configure
ip Global IP configuration
subcommands
ipv6 Global IPv6 configuration
subcommands
lacp Configure LACP
line Configure a terminal line
linecard Configure linecard
link-bundle-distribution Configure link-bundle
load-balance Global traffic load-balance
configuration
logging Modify message logging
facilities
mac Global MAC configuration
subcommands
mac-address-table Mac Address Table
Configuration Subcommands
management Create a management crypto or
route, etc
monitor Monitor monitored ports
no Reset a command
ntp Configure NTP
openflow Configure OpenFlow instance
password-attributes Configure password attributes
policy-map-input Configure input QoS policy map
policy-map-output Configure output QoS policy map
port-channel Configure port-channel group
parameters
privilege Command privilege parameters
protocol Select a protocol to configure
protocol-tunnel Configure protocol tunneling
qos-policy-input Configure input QoS policy
qos-policy-output Configure output QoS policy
qos-rate-adjust Configure the number of bytes
added to each frame for rate policing/shaping
radius-server Set up RADIUS server
redundancy Set up linecard redundancy
configuration
reload-type Configure the reload type
rmon Configure RMON alarm/event
tables
route-map Create route-map or enter
route-map command mode
router Enable a routing process
script Start or stop a script
CLI Basics
51