Reference Guide

out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
neighbor maximum-prefix
Control the number of network prefixes received.
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} maximum-prefix
maximum [threshold] [warning-only]
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} maximum-prefix maximum [threshold] [warning-only]
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes
allowed for this BGP router. The range is 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the software sends a
message. The range is 1 to 100 percent. The default is 75.
warning-only (OPTIONAL) Enter the keywords warning-only to set the
router to send a log message when the maximum value is
reached. If you do not set this parameter, the router stops
peering when the maximum number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Border Gateway Protocol
569