Reference Guide

Version Description
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-
client
To indicate that the neighbor is not a route reflector client or to delete a route
reflector configuration, use the no neighbor {ipv6-address | peer-group-
name} route-reflector-client command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name Enter the name of the peer group. All routers in the peer
group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information
The first time you enter this command it configures the neighbor as a route
reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers
do not need to be fully meshed if you configure a route reflector.
576
Border Gateway Protocol