Reference Guide

Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address
families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
C9000 Series
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number Enter a subnet number in dotted decimal format (A.B.C.D.)
as the allowable range of addresses included in the peer
group. To allow all addresses, enter 0::0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command Modes ROUTER BGP
578
Border Gateway Protocol