Reference Guide

If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload
conditional nvram-cfg-change.
cam-acl-egress
Allocate CAM for egress ACLs.
C9000 Series
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl
number}
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number
ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
range for ipv4acl is from 1 to 4. The ipv6acl range must be a
factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
cam-acl-egress-pe
Allocate CAM for egress ACLs on the port extender.
C9000 Series
Syntax
cam-acl-egress-pe {12acl number ipv4acl number ipv6acl number}
Parameters
l2acl Allocates space for the L2 ACL. The default value is 5
608
Content Addressable Memory (CAM)