Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Guidelines
Select the CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3
(IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address
validation for DHCP, and Policy-based Routing (PBR). Save the new CAM settings
to the startup-config (write-memor copy run start) then reload the system for
the new settings to take effect. The total amount of space allowed is 12 FP Blocks.
System flow requires three blocks; these blocks cannot be reallocated.
The ipv4acl profile range is from 1 to 4. When configuring space foripv6acl, the
total number of Blocks must equal 13. Ranges for the CAM profiles are from 1 to 10,
except for the ipv6acl profile which is from 0 to 10. The ipv6acl allocation must
be a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM
regions, the value is 0.
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
C9000 Series
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
610
Content Addressable Memory (CAM)