Reference Guide

Q6 CP 500
GVRP 01:80:c2:00:00:21 any
Q12 RP 200
STP 01:80:c2:00:00:00 any
Q13 RP 150
ISIS 01:80:c2:00:00:14/15 any
Q13 RP 500
09:00:2b:00:00:04/05 any
Q13 RP 500
show protocol-queue-mapping
Display the protocol-queue mapping for each configured protocol.
C9000 Series
Syntax
show protocol-queue-mapping [queue-id queue-number]
Parameters
queue-id queue-
number
(Optional) Display the protocol-queue mapping for a
specified control-plane queue. The range of CPU queue
numbers is from 0 to 20.
Defaults Not configured.
Command Modes EXEC Privilege
Usage Information
The show output displays information on CPU traffic flows for all protocols,
including the ingress queue at which the traffic is queued and the CPU to which
protocol traffic is sent with the applied rate limits (configured or default) in kilobits
per second (kbps). The egress port queues on CPUs are abbreviated as: RP (Route
Processor), CP (Control Processor), and LC (line card).
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Example
Dell#show protocol-queue-mapping | no-more
Protocol Queue EgPort
CommitRate(kbps) Peak Rate(kbps) CommitBurst(kb) Peak Burst(kb)
Control Plane Policing (CoPP)
633