Reference Guide

systemTempMonitorLEDTest: ALL RUN NO NO
NO NO YES
tsensorAccess: ALL RUN YES NO
NO NO NO
usbAccess: ALL RUN YES NO
NO NO NO
usbPowerEnable: ALL RUN YES NO
NO NO NO
usbRW: ALL RUN NO YES
NO NO NO
usbStatus: ALL RUN YES NO
NO NO NO
watchdogTimer: ALL RUN NO NO
NO NO YES
Hardware Commands
The hardware commands supported on the switch allow you to display information from a hardware
sub-component or ASIC.
clear control-traffic
Clear control-traffic statistics from the CPU.
C9000 Series
Syntax
clear control—traffic {all | cp—switch | linecard slot-id
portset port-pipe} counters
Parameters
cp-switch Enter the keyword cp-switch to clear the counters for
control traffic on the control plane.
linecard slot-id
portset port-pipe
Enter the slot ID and port pipe to clear the counters for
control traffic on a specified switch line card and port set.
The range of slot IDs is from 0 to 2. The range of port-pipe
numbers is: 0 to 2 on line card 0 and 0 to 3 on line cards 1
and 2.
all Enter the keyword all to clear control-traffic statistics on
the control plane and all line cards.
Defaults None.
Command Modes EXEC Privilege
Example
Dell# clear control-traffic cp-switch counters
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Debugging and Diagnostics
717