Reference Guide

flags=0x10204, Installed, Enabled
tcam: color_indep=0,
IpType
Offset: 208 Width: 5
DATA=0x00000004
MASK=0x0000000c
L3Routable
Offset: 166 Width: 1
DATA=0x00000001
MASK=0x00000001
OutPort
Offset: 195 Width: 7
DATA=0x00000001
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 110 slice = 0 idx=4 entries=1}
{Packets}
Usage Information The port-set values are internal port numbers.
show hardware mac
Display information about the MAC ACLs used on a line card and port-sets.
C9000 Series
Syntax
show hardware mac {eg-acl {pe pe-id stack-unit unit-number port-
set port-pipe-id counters | linecard slot-id port-set number}|
in-acl {pe pe-id stack-unit unit-number port-set port-pipe-id
counters | linecard slot-id port-set number }}
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to
display ingress or egress ACL data.
linecardslot-id Enter the linecard slot-id parameters to specify a line
card. The range of slot IDs is from 0 to 11.
pe pe-id Enter the pepe-id parameters to specify a port extender (PE).
The PE ID range is from 0 to 255.
NOTE: The pe option is only visible when the extended
bridge feature is enabled.
stack-unit unit-
number
Enter the stack-unitunit-number parameters to specify a
stack-unit. The stack-unit range is from 0 to 7.
port-set number Enter the keyword port-set number parameters to specify a
port pipe (set of ports) on a line card. The port set number is
0.
counters Enter the keyword counters to display counter statistics.
Defaults none
Command Modes EXEC Privilege
746
Debugging and Diagnostics