Reference Guide

interface interface Enter the keyword interface then type one of the
following interface types and slot/port or number
information:
• For a 1–Gigabit Ethernet interface, enter the keyword
gigabitethernet.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
• For a Port Channel interface, enter the keyword port-
channel then a number. Range is from 1 to 128.
• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigabitEthernet then the pe-id,
stack-unit
unit number, and port-id. The pe-id range is
0–255; the stack unit number range is 0–7; and the port
—ID range is 0 –47.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
Related
Commands
clear ip dhcp snooping — clears the contents of the DHCP binding table.
Dynamic Host Configuration Protocol (DHCP)
785