Reference Guide

Dell(conf-if-te-5/0)#do reload

System configuration has been modified. Save? [yes/no]: n

Proceed with reload [confirm yes/no]: n

Dell(conf-if-te-5/0)#

enable

Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may

need to enter a password.

C9000 Series

Syntax

enable [level]

From a PE console, use enable [level] to enter EXEC privilege mode .

Parameters

level (OPTIONAL) Enter a number for a privilege level of Dell

Networking OS. The range is from 0 to 15.

Defaults 15

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010 and C1048P.

9.5(0.1) Added support for roles on the Z9500.

9.5(0.0) Added support for roles on the Z9000, S6000, S4820T,

S4810, MXL

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Control and Monitoring