Reference Guide

Usage Information Users entering EXEC Privilege mode or any other configured privilege level can
access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
at a specific privilege level. If no privilege level is specified, the default is privilege
level 15. You can also use the enable [level] command from a PE console to
enter the privileged mode.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
Related
Commands
enable password — configures a password for the enable command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
C9000 Series
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval seconds Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Replacement command for the S4820T. Replaces the
enable xfp-power-updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the
enable xfp-power-updates command
80
Control and Monitoring