Reference Guide

17
Flex Hash and Optimized Boot-Up
This chapter describes the Flex Hash and fast-boot enhancements.
encapsulation dot1q
Configures lite-subinterfaces. This command is supported on the S6000 platform.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no version of this
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which
the host belongs. The range is from 1 to 4094. A lite
subinterface is considered as a Layer 3 port property and is
synchronous with the existing rules of applying Layer 2 or
Layer 3 properties to an interface.
Command Modes
INTERFACE
Command History
Version
9.9(0.0) Introduced on the C9010.
9.3.0.0 Introduced on the S6000 platform.
Usage Information To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID
of 4095 and this mapping is performed using VLAN translation. After VLAN
translation, the RRoCE packets are considered in the same manner as normal IP
packets that are received on Layer 3 interface and routed in the egress direction. At
the egress interface, the VLAN ID is appended to the packet and transmitted out of
the interface as a tagged packet with the dot1Q value preserved. The dot1Q value is
preserved only for egress interfaces that are associated with a VLAN or a lite-
subinterface . If a Layer 3 interface is configured without the encapsulation 802.1Q
VLAN ID or is an untagged interface in a VLAN , the dot1Q value is not preserved .
Flex Hash and Optimized Boot-Up
821