Reference Guide

gvrp registration
Configure the GVRP register type.
C9000 Series
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed then the VLAN range in a comma-
separated VLAN ID set.
normal Enter the keyword normal then the VLAN range in a
comma-separated VLAN ID set. This setting is the default.
forbidden Enter the keyword forbidden then the VLAN range in a
comma-separated VLAN ID set.
Defaults normal
Command Modes CONFIGURATION-INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage Information
Fixed registration prevents an interface, configured using the command line, to
belong to a VLAN (static configuration) from being unconfigured when it receives a
Leave message. Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port’s membership in the VLAN
depends on GVRP. The interface becomes a member of a VLAN after learning
about the VLAN through GVRP. If the VLAN is removed from the port that sends
GVRP advertisements to this device, the port stops being a member of the VLAN.
To advertise or learn about VLANs through GVRP, use the forbidden command
when you do not want the interface.
844
GARP VLAN Registration (GVRP)