Reference Guide

Interfaces

The Dell Networking OS supports the interface configuration commands described in this chapter.

This chapter contains the following sections:

• Basic Interface Commands

• EIS Commands

• Port Channel Commands

• High-Gigabit Port Channel Commands

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

clear counters

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol

(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.

C9000 Series

Syntax

clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit

| vlan vlan-id]

Parameters

interface (OPTIONAL) Enter any of the following keywords and slot/

port, pe-id/stack-unit/port or number to clear counters

from a specified interface:

• For IPv4 access-group counters, enter the keyword ip.

• For IPv6 access-group counters, enter the keyword

ipv6.

• For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

• For MAC access-group counters, enter the keyword mac.

• For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port (ports, port-

range) information.

• For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

• For the management interface on the RPM, enter the

keyword ManagementEthernet then slot/port

Interfaces

861