Reference Guide

range (Optional) Enter the keyword range to configure an
interface range.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
interface’s configuration does not contain an IP address and enter the switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
Example
Dell(conf)# int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Example peGigE
Dell#show interfaces peGigE 0/0/0
peGigE 0/0/1 is up, line protocol is up
Hardware is DellEth, address is a0:68:00:3f:92:bd
Current address is a0:68:00:3f:92:bd
Pluggable media not present
Interface index is 536870919
Internet address is not set
874
Interfaces