Reference Guide

Example
Dell(conf)#int peg 255/1/0
Dell(conf-if-pegi-255/1/0)#sho con
!
interface peGigE 255/1/0
dampening 20 200 800 80
no shutdown
Dell(conf-if)# show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
C9000 Series
Syntax
show config
Command Modes INTERFACE RANGE (conf-if-range)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
896
Interfaces