Reference Guide

Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Time since last interface status change: 00:55:34
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces dampening
Display interface dampening information.
C9000 Series
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
interface (Optional) Enter one of the following keywords and slot/port
or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE: The peGigE output is only visible when the
feature extended bridge feature is enabled.
summary (OPTIONAL) Enter the keyword summary to display the
current summary of dampening data, including the number
of interfaces configured and the number of interfaces
suppressed, if any.
detail (OPTIONAL) Enter the keyword detail to display detailed
interface dampening data.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
916
Interfaces