Reference Guide

ip http source-interface

Configure an interface’s IP address as the source IP address for HTTP connections.

C9000 Series

Syntax

ip http source-interface interface

To delete an interface, use theno ip http source-interface interface

command.

Parameters

interface

Enter the following keywords and slot/port or number

information:

• For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

• For a Port Channel interface, enter the keyword port-

channel then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.

8.3.11.1 Introduced on the Z9000

8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was

2094)

8.1.1.0 Introduced on E-Series ExaScale

7.6.1.0 Support added for S-Series

Control and Monitoring