Reference Guide
Version Description
7.5.1.0 Introduced on C-Series
ip telnet server enable
Enable the Telnet server on the switch.
C9000 Series
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
C9000 Series
Syntax
ip telnet source-interface interface
Control and Monitoring
93