Reference Guide

G - GVRP tagged, M - Trunk
i - Internal untagged, I-Internal tagged, v-VLT
untagged, V-VLT tagged
Name: TenGigabitEthernet 10/0
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 10/1
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Related
Commands
• interface — configures a physical interface on the switch.
• show ip interface — displays Layer 3 information about the interfaces.
• show interfaces — displays information on a specific physical interface or virtual
interface.
• show interfaces transceiver — displays the physical status and operational status
of an installed transceiver. The output also displays the transceiver’s serial
number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
C9000 Series
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port | peGigE pe-id/stack-unit/port ] transceiver
Parameters
tengigabitethernet For a 10G interface, enter the keyword
tengigabitethernet then the slot/port (ports or port
range) information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the
slot/port (ports or port-range)information.
peGigE For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range
is from 1 to 48.
NOTE: The peGigE option is only visible when the
feature extended bridge feature is enabled.
Command Modes
• EXEC
Interfaces
935