Reference Guide

• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output augmented with diagnostic data for pluggable
media.
7.7.1.0 Removed three fields in the output: Vendor Name, Vendor
OUI, and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage Information The following describes the show interfaces transceiver command shown
in the following example.
Line Description
Rx Power
measurement
type
Output depends on the vendor, typically either “Average” or
“OMA” (Receiver optical modulation amplitude).
Temp High Alarm
threshold
Factory-defined setting, typically in Centigrade. Value differs
between SFPs and SFP+.
Voltage High
Alarm threshold
Displays the interface index number that SNMP uses to
identify the interface.
Bias High Alarm
threshold
Factory-defined setting. Value can differ between SFP and
SFP+.
TX Power High
Alarm threshold
Factory-defined setting. Value can differ between SFP and
SFP+.
RX Power High
Alarm threshold
Factory-defined setting. Value can differ between SFP and
SFP+.
Temp Low Alarm
threshold
Factory-defined setting. Value can differ between SFP and
SFP+.
936
Interfaces