Reference Guide

show range
Display all interfaces configured using the interface range command.
C9000 Series
Syntax
show range
Command Modes INTERFACE RANGE (config-if-range)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Example
Dell(conf)#interface range peGigE 255/1/2
Dell(conf-if-range-pegi-255/1/2)#show range
interface peGigE255/1/2 - 0
Related
Commands
• interface — configures a physical interface on the switch.
• show ip interface — displays Layer 3 information about the interfaces.
• show interfaces — displays information on a specific physical interface or virtual
interface.
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the
ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40
interfaces (not just LAG link-bundles).
C9000 Series
Syntax
show running-config ecmp-group
Interfaces
945