Setup Guide

Description Behavior at Peer Up Behavior During Run Time Action to Take
System MAC mismatch A syslog error message and an
SNMP trap are generated.
A syslog error message and an
SNMP trap are generated.
Verify that the unit ID of VLT
peers is not the same on both
units and that the MAC address
is the same on both units.
Unit ID mismatch
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message is
generated.
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message is
generated.
Verify the unit ID is correct on
both VLT peers. Unit ID numbers
must be sequential on peer units;
for example, if Peer 1 is unit ID
“0”, Peer 2 unit ID must be “1’.
Version ID mismatch A syslog error message and an
SNMP trap are generated.
A syslog error message and an
SNMP trap are generated.
Verify the Dell EMC Networking
OS software versions on the VLT
peers is compatible. For more
information, refer to the Release
Notes for this release.
VLT LAG ID is not congured on
one VLT peer
A syslog error message is
generated. The peer with the
VLT congured remains active.
A syslog error message is
generated. The peer with the
VLT congured remains active.
Verify the VLT LAG ID is
congured correctly on both VLT
peers.
VLT LAG ID mismatch
The VLT port channel is brought
down.
A syslog error message is
generated.
The VLT port channel is brought
down.
A syslog error message is
generated.
Perform a mismatch check after
the VLT peer is established.
Reconguring Stacked Switches as VLT
To convert switches that have been stacked to VLT peers, use the following procedure.
1 Remove the current conguration from the switches. You will need to split the conguration up for each switch.
2 Copy the les to the ash memory of the appropriate switch.
3 Copy the les on the ash drive to the startup-cong.
4 Reset the stacking ports to user ports for both switches.
5 Reload the stack and conrm the new congurations have been applied.
6 On the Secondary switch (stack-unit1), enter the command stack-unit1 renumber 0.
7 Conrm the reload query.
8 After reloading, conrm that VLT is enabled.
9 Conrm that the management ports are interconnected or connected to a switch that can transfer Heartbeat information.
Specifying VLT Nodes in a PVLAN
You can congure VLT peer nodes in a private VLAN (PVLAN). VLT enables redundancy without the implementation of Spanning Tree
Protocol (STP), and provides a loop-free network with optimal bandwidth utilization.
Because the VLT LAG interfaces are terminated on two dierent nodes, PVLAN conguration of VLT VLANs and VLT LAGs are
symmetrical and identical on both the VLT peers. PVLANs provide Layer 2 isolation between ports within the same VLAN. A PVLAN
partitions a traditional VLAN into sub-domains identied by a primary and secondary VLAN pair. With VLT being a Layer 2 redundancy
mechanism, support for conguration of VLT nodes in a PVLAN enables Layer 2 security functionalities. To achieve maximum VLT resiliency,
you should congure the PVLAN IDs and mappings to be identical on both the VLT peer nodes.
Virtual Link Trunking (VLT)
1131