Setup Guide

CONFIGURATION-UDF-Qualier-Value Prole mode
udf-id 1-12 value mask
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
11 Associate the UDF qualier value with a UDF packet prole in an IP access list.
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
permit ip {source mask | any | host ip-address} {destination mask | any | host ip-address}
udf-pkt-format name udf-qualifier-value name
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-qualifier-value ipnip_val1
12 View the UDF TCAM conguration.
CONFIGURATION-UDF TCAM mode
show config
Dell(config-ext-nacl)#show config
!
ip access-list extended aa
seq 5 permit ip any any udf-pkt-format ipnip udf-qualifier-value ipnip_val1
Dell(config-ext-nacl)#
Hot-Lock Behavior
Dell Networking OS hot-lock features allow you to append and delete their corresponding content addressable memory (CAM) entries
dynamically without disrupting trac. Existing entries are simply shued to accommodate new entries.
Hot-Lock IP ACLs allow you to append rules to and delete rules from an access control list (ACL) that is already written to CAM. This
behavior is enabled by default and is available for both standard and extended ACLs on ingress and egress. For information about
conguring ACLs, see Access Control Lists (ACLs).
Access Control Lists (ACLs)
149