Setup Guide

DCBx Prerequisites and Restrictions
The following prerequisites and restrictions apply when you congure DCBx operation on a port:
•
For DCBx, on a port interface, enable LLDP in both Send (TX) and Receive (RX) mode (the protocol lldp mode command; refer
to the example in CONFIGURATION versus INTERFACE Congurations in the Link Layer Discovery Protocol (LLDP) chapter). If
multiple DCBx peer ports are detected on a local DCBx interface, LLDP is shut down.
• The CIN version of DCBx supports only PFC, ETS, and FCOE; it does not support iSCSI, backward congestion management (BCN),
logical link down (LLDF), and network interface virtualization (NIV).
Conguring DCBx
To congure DCBx, follow these steps.
For DCBx, to advertise DCBx TLVs to peers, enable LLDP. For more information, see Link Layer Discovery Protocol (LLDP).
Congure DCBx operation at the interface level on a switch or globally on the switch.
1 Congure ToR- and FCF-facing interfaces as auto-upstream ports.
2 Congure server-facing interfaces as auto-downstream ports.
3 Congure a port to operate in a conguration-source role.
4 Congure ports to operate in a manual role.
NOTE
: The DCBx conguration is not supported on cascade interfaces or extended ports
1 Enter INTERFACE Conguration mode.
CONFIGURATION mode
interface type slot/port
2 Enter LLDP Conguration mode to enable DCBx operation.
INTERFACE mode
[no] protocol lldp
3 Congure the DCBx version used on the interface, where: auto congures the port to operate using the DCBx version received from
a peer.
PROTOCOL LLDP mode
[no] DCBx version {auto | cee | cin | ieee-v2.5}
• cee: congures the port to use CEE (Intel 1.01).
• cin: congures the port to use Cisco-Intel-Nuova (DCBx 1.0).
• ieee-v2.5: congures the port to use IEEE 802.1Qaz (Draft 2.5).
The default is Auto.
4 Congure the DCBx port role the interface uses to exchange DCB information.
PROTOCOL LLDP mode
[no] DCBx port-role {config-source | auto-downstream | auto-upstream | manual}
• auto-upstream: congures the port to receive a peer conguration. The conguration source is elected from auto-upstream
ports.
• auto-downstream: congures the port to accept the internally propagated DCB conguration from a conguration source.
• config-source: congures the port to serve as the conguration source on the switch.
Data Center Bridging (DCB)
287