Setup Guide

Congure the System to be a DHCP Client
A DHCP client is a network device that requests an IP address and conguration parameters from a DHCP server.
Implement the DHCP client functionality as follows:
• The switch can obtain a dynamically assigned IP address from a DHCP server. A start-up conguration is not received. Use bare metal
provisioning (BMP) to receive conguration parameters (OS version and a conguration le). BMP is enabled as a factory-default
setting on a switch.
A switch cannot operate with BMP and as a DHCP client simultaneously. To disable BMP in EXEC mode, use the stop bmp command.
After BMP stops, the switch acts as a DHCP client.
• Acquire a dynamic IP address from a DHCP client is for a limited period or until the client releases the address.
• A DHCP server manages and assigns IP addresses to clients from an address pool stored on the server. For more information, refer to
Conguring the Server for Automatic Address Allocation.
• Dynamically assigned IP addresses are supported on 10-Gigabit and 40-Gigabit interfaces. The DHCP client is supported on VLAN and
port-channel interfaces.
• The public out-of-band management interface and default VLAN 1 are congured by default as a DHCP client to acquire a dynamic IP
address from a DHCP server.
DHCP Client on a Management Interface
These conditions apply when you enable a management interface to operate as a DHCP client.
• The management default route is added with the gateway as the router IP address received in the DHCP ACK packet. It is required to
send and receive trac to and from other subnets on the external network. The route is added irrespective when the DHCP client and
server are in the same or dierent subnets. The management default route is deleted if the management IP address is released like
other DHCP client management routes.
• ip route for 0.0.0.0 takes precedence if it is present or added later.
• Management routes added by a DHCP client display with Route Source as DHCP in the show ip management route and show
ip management-route dynamic command output.
• Management routes added by DHCP are automatically reinstalled if you congure a static IP route with the ip route command that
replaces a management route added by the DHCP client. If you remove the statically congured IP route using the no ip route
command, the management route is reinstalled. Manually delete management routes added by the DHCP client.
• To reinstall management routes added by the DHCP client that is removed or replaced by the same statically congured management
routes, release the DHCP IP address and renew it on the management interface.
• Management routes added by the DHCP client have higher precedence over the same statically congured management route. Static
routes are not removed from the running conguration if a dynamically acquired management route added by the DHCP client
overwrites a static management route.
• Management routes added by the DHCP client are not added to the running conguration.
NOTE
: Management routes added by the DHCP client include the specic routes to reach a DHCP server in a dierent subnet
and the management route.
DHCP Client Operation with Other Features
A DHCP client also operates with the following software features.
Virtual Link Trunking (VLT)
A DHCP client is not supported on VLT interfaces.
Dynamic Host
Conguration Protocol (DHCP) 359