Setup Guide
Figure 49. C9010 Slot Numbering
To congure a C9010 port, specify the interface with the command syntax:
interface {TenGigabitEthernet | fortyGigE} slot/port-number
• The slot is a chassis slot number from 0 to 11.
• port-number is a linecard port number from 0 to 23 or an RPM port number from 0 to 3.
NOTE
: For slots 10 and 11, the port number is from 0 to 3 only.
On the C9010, port interface numbers are written above the ports. The following examples show port numbering on C9010 line cards
(40GbE QSFP+, 1/10GbE SFP+, and 1/10GbE RJ-45).
Figure 50. 40GbE QSFP+ Port Numbering
On the 6-Port 40GbE QSFP+ line card, ports are numbered from 0 to 5 and operate by default in 40GbE mode. If you use a breakout cable,
each port can operate in 10G mode. 40GbE ports are numbered in multiples of four, starting with zero; for example, 0, 4, 8, 12, and so on.
When you install a breakout cable, the resulting four 10GbE ports are numbered with the remaining numbers. For example, 40GbE port 0
contains 10GbE ports 0, 1, 2, and 3; 40GbE port 4 contains 10GbE ports 4, 5, 6, and 7.
440
Interfaces