Setup Guide

Console Port RJ-45 to RJ-45 Rollover
Cable
RJ-45 to RJ-45 Rollover
Cable
RJ-45 to DB-9 Adapter Terminal Server Device
Signal RJ-45 Pinout RJ-45 Pinout DB-9 Pin Signal
TxD 3 6 2 RxD
GND 4 5 5 GND
GND 5 4 5 GND
RxD 6 3 3 TxD
NC 7 2 4 DTR
CTS 8 1 7 RTS
Mounting an NFS File System
This feature enables you to quickly access data on an NFS mounted le system. You can perform le operations on an NFS mounted le
system using supported le commands.
This feature allows an NFS mounted device to be recognized as a le system. This le system is visible on the device and you can execute
all le commands that are available on conventional le systems such as a Flash le system.
Before executing any CLI command to perform le operations, you must rst mount the NFS le system to a mount-point on the device.
Since multiple mount-points exist on a device, it is mandatory to specify the mount-point to which you want to load the system.
The /f10/mnt/nfsdirectory is the root of all mount-points.
To mount an NFS le system, perform the following steps:
Table 3. Mounting an NFS File System
File Operation Syntax
To mount an NFS le system:
mount nfs rhost:path mount-
point username password
The foreign le system remains mounted as long as the device is up and does not reboot. You can run the le system commands without
having to mount or un-mount the le system each time you run a command. When you save the conguration using the write command,
the mount command is saved to the startup conguration. As a result, each time the device re-boots, the NFS le system is mounted
during start up.
Table 4. Forming a
copy Command
Location source-le-url Syntax destination-le-url Syntax
For a remote le location:
NFS File System
copy nfsmount://{<mount-
point>}/filepath/filename}
username:password
tftp://{hostip | hostname}/
filepath/filename
Important Points to Remember
• You cannot copy a le from one remote system to another.
• You cannot copy a le from one location to the same location.
• When copying to a server, you can only use a hostname if a domain name server (DNS) server is congured.
• The usbflash command is supported on the device. Refer to your system’s Release Notes for a list of approved USB vendors.
50
Getting Started