Setup Guide

The default is: Compellent disk arrays are not detected.
NOTE: The [no] iscsi profile-compellent. command is not supported on cascade interfaces or extended
ports
Displaying iSCSI Optimization Information
To display information on iSCSI optimization, use the following show commands.
• Display the currently congured iSCSI settings.
show iscsi
• Display information on active iSCSI sessions on the switch.
show iscsi session
• Display detailed information on active iSCSI sessions on the switch. To display detailed information on specied iSCSI session, enter the
session’s iSCSI ID.
show iscsi sessions detailed [session isid]
• Display all globally congured non-default iSCSI settings in the current Dell Networking OS session.
show run iscsi
NOTE:
The switch learns only the active iSCSI sessions which it observes; sessions owing through an adjacent switch are not learned.
After you reload the switch, iSCSI session information exchanged during the initial handshake is not available. If the switch picks up
session communication after reloading, it detects iSCSI sessions in progress but sometimes cannot obtain complete session
information. Incomplete information about active iSCSI sessions is not displayed in show iscsi session command output.
In a VLT conguration, show iscsi session output is not accurate unless there are iSCSI trac ows on VLT LAGs on both the
target and the initiator side of the VLT domain.
Examples of the show iscsi Commands
The following example shows the show iscsi command.
Dell#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
The following example shows the show iscsi session command.
VLT PEER1
Dell#show iscsi session
Session 0:
----------------------------------------------------------------------------
Target: iqn.2001-05.com.equallogic:0-8a0906-0e70c2002-10a0018426a48c94-iom010 Initiator:
iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
VLT PEER2
Session 0:
-----------------------------------------------------------------------------
Target: iqn.2001-05.com.equallogic:0-8a0906-0f60c2002-0360018428d48c94-iom011
iSCSI Optimization
551