Setup Guide

DellEMC(conf)#service timestamps log uptime

DellEMC# show command-history

- Repeated 1 time.

[May 17 10:20:37]: CMD-(CLI):[configure]by default from console

- Repeated 1 time.

[1d0h24m]: CMD-(CLI):[service timestamps log uptime]by default from console

[1d0h24m]: CMD-(CLI):[interface tengigabitethernet 1/1]by default from console

[1d0h24m]: CMD-(CLI):[shutdown]by default from console

[1d0h24m]: CMD-(CLI):[no shutdown]by default from console

[1d0h25m]: CMD-(CLI):[end]by default from console

[1d0h25m]: CMD-(CLI):[write memory]by default from console

- Repeated 1 time.

[1d0h25m]: CMD-(CLI):[show clock]by default from console

[1d0h25m]: CMD-(CLI):[show version]by default from console

[1d0h25m]: CMD-(CLI):[show logging]by default from console

[1d0h25m]: CMD-(CLI):[show command-history]by default from console

Example 4: no service timestamps log

DellEMC(conf)#no service timestamps log

DellEMC# show command-history

- Repeated 1 time.

[1d0h26m]: CMD-(CLI):[configure]by default from console

- Repeated 1 time.

[May 17 15:53:10]: CMD-(CLI):[no service timestamps log]by default from console

[May 17 15:53:16]: CMD-(CLI):[write memory]by default from console

- Repeated 3 times.

[May 17 15:53:22]: CMD-(CLI):[show logging]by default from console

- Repeated 1 time.

[May 17 15:53:36]: CMD-(CLI):[write memory]by default from console

- Repeated 5 times.

[May 17 15:53:44]: CMD-(CLI):[show logging]by default from console

[May 17 15:53:53]: CMD-(CLI):[show command-history]by default from console

[May 17 15:54:54]: CMD-(CLI):[end]by default from console

[May 17 15:55:00]: CMD-(CLI):[show logging]by default from console

[May 17 15:55:12]: CMD-(CLI):[show clock]by default from console

[May 17 15:55:22]: CMD-(CLI):[show running-config]by default from console

[May 17 15:55:27]: CMD-(CLI):[show command-history]by default from console

Upgrading the Dell Networking OS

To upgrade the Dell Networking operating system on the switch, refer to the Release Notes for the software version you want to load.

NOTE

: If VLT is already congured in a device loaded with Dell Networking OS version 9.9(0.0), you must rst remove the VLT

conguration to upgrade to the Dell Networking OS version 9.10(0.0) or later. After removing the VLT conguration, upgrade

each VLT node and its corresponding single-homed PE individually and then reload both nodes as well as PEs. After the CBs and

PEs come up with Dell Networking OS version 9.10(0.0) or later, congure VLT again. When you congure VLT, the PEs rst go

down and then come up.

For information about how to verify newly copied or currently running software images, see:

• Using Hashes to Validate Software Images

Getting Started