Setup Guide
• udp — User Datagram Protocol
bit — (Optional) For TCP protocol type only,
enter one or a combination of the following
TCP ags:
• ack = acknowledgement
• n = nish (no more data from the user)
• psh = push function
• rst = reset the connection
• yn = synchronize sequence numbers
• urg = urgent eld
operators — For TCP and UDP parameters
only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you
must specify two ports for the port
command parameter.)
source ip-address or any or host ip-address
(Optional) — Source’s IP address or host
from which they packets were sent.
mask (Optional) — network mask /prex
format (/x).
any (Optional) — Species that all trac is
subject to the lter.
destination mask — IP address of the
network or host to which the packets are
sent.
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
Below is an example:
Dell(conf-redirect-
list)#redirect 1.1.1.1 tcp an
any ?
ack Match
on the ack bit
eq Match
only packets on a given port
number
fin Match
on the fin bit
gt Match
only packets with a greater
port number
lt Match
only packets with a lower port
number
neq Match
only packets not on a given
port number
psh Match
Policy-based Routing (PBR)
745