Setup Guide

• If queued packets fall below the minimum threshold, they are transmitted.
• If queued packets exceed the maximum threshold, they are dropped.
ECN Packet Classication
When ECN for WRED is enabled on an interface, non-ECN-capable packets are marked as green-proled trac and are subject to early
WRED drops. For example, TCP-acks, OAM, and ICMP ping packets are non-ECN-capable. However, it is not desirable for these packets to
be WRED-dropped. You can use ECN match criteria in an ingress class map or an ACL to classify ECN-capable and non-ECN-capable
packets and apply the appropriate color-based WRED action.
Standard and extended IPv4 ACLs support the use of the 2-bit ECN eld in packet headers as L3 deny/permit criteria for IP, TCP, UDP, and
ICMP packets. Enter the keyword ecn in a deny/permit statement to mark ingress trac according to its ECN-capability or non-capability.
You can specify DSCP and ECN classiers in the same ACL entry in an IP standard or extended ACL.
In a match-any class map, you can mark selected ECN/non-ECN trac for yellow handling by entering set-color yellow in any of the
following L3 match commands:
• match ip access-group
• match ip dscp
• match ip precedence
• match ip vlan
By default, all packets are marked for green handling if the rate-police and trust-diserv commands are not used in an ingress policy map.
All packets marked for red handling or “violate” are dropped.
In the class map, in addition to color-marking matching packets for yellow handling, you can also congure a DSCP value for matching
packets.
When you use ECN to classify and color-mark packets in an ingress class map, take into account:
• When all matching packets are marked for yellow treatment, policer-based coloring is not supported at the same time.
• If a single-rate two-color policer is congured at the same time as ECN-matched packets are set for yellow handling, by default all
packets less than PIR are marked for “green” handling. All green packets selected by ECN match criteria and color-marked yellow are
over-written and marked for yellow handling.
• If a two-rate three-color policer is congured at the same time as ECN-matched packets are set for yellow handling:
– x < CIR is marked as green.
– CIR < x< PIR is marked as yellow.
– PIR < x is marked as red.
Green packets matching the ECN criteria for which yellow color-marking is congured are overwritten and marked as yellow.
Example: Color-marking non-ECN Packets in One Trac Class
The following example shows how to mark non-ECN packets for “yellow” handling when all packets egress on the default queue 0. Non-
ECN-capable packets have the ECN eld in their packet headers set to 0.
ip access-list standard ecn_0
seq 5 permit any ecn 0
class-map match-any ecn_0_cmap
match ip access-group ecn_0 set-color yellow
Quality of Service (QoS)
865