Setup Guide
Table 87. RIP Defaults
Feature Default
Interfaces running RIP
• Listen to RIPv1 and RIPv2
• Transmit RIPv1
RIP timers
• update timer = 30 seconds
• invalid timer = 180 seconds
• holddown timer = 180 seconds
• ush timer = 240 seconds
Auto summarization Enabled
ECMP paths supported 16
Conguration Information
By default, RIP is disabled on the switch.
To congure RIP, you must use commands in two modes: ROUTER RIP and INTERFACE. Commands executed in the ROUTER RIP mode
congure RIP globally, while commands executed in the INTERFACE mode congure RIP features on that interface only.
RIP is best suited for small, homogeneous networks. You must congure all devices within the RIP network to support RIP if they are to
participate in the RIP.
Conguration Task List
The following is the conguration task list for RIP.
• Enabling RIP Globally (mandatory)
• Congure RIP on Interfaces (optional)
• Controlling RIP Routing Updates (optional)
• Setting Send and Receive Version (optional)
• Generating a Default Route (optional)
• Controlling Route Metrics (optional)
• Summarize Routes (optional)
• Controlling Route Metrics
• Debugging RIP
For a complete listing of all commands related to RIP, refer to the Dell Networking OS Command Reference Interface Guide.
Enabling RIP Globally
By default, RIP is disabled on the switch.
To enable RIP globally, use the following commands.
1 Enter ROUTER RIP mode and enable the RIP process.
CONFIGURATION mode
router rip
2 Assign an IP network address as a RIP network to exchange routing information.
ROUTER RIP mode
Routing Information Protocol (RIP)
873