Setup Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

100

Examples of Verifying that 802.1X is Enabled Globally or on an Interface

Verify that 802.1X is enabled globally and at the interface level using the show running-config | find dot1x command from

EXEC Privilege mode.

The bold text show that 802.1x has been enabled. By default, ports are not authorized.

Dell#show running-config | find dot1x

dot1x authentication

[output omitted]

interface TenGigabitEthernet 2/1

no ip address

dot1x authentication

no shutdown

Dell#

View 802.1X conguration information for an interface using the show dot1x interface command.

The bold lines show that 802.1X is enabled on all ports unauthorized by default.

Dell#show dot1x interface TenGigabitEthernet 2/1

802.1x information on Te 2/1:

-----------------------------

Dot1x Status: Enable

Port Control: AUTO

Port Auth Status: UNAUTHORIZED

Re-Authentication: Disable

Untagged VLAN id: None

Guest VLAN: Disable

Guest VLAN id: NONE

Auth-Fail VLAN: Disable

Auth-Fail VLAN id: NONE

Auth-Fail Max-Attempts: NONE

Critical VLAN: Disable

Critical VLAN id: NONE

Mac-Auth-Bypass: Enable

Mac-Auth-Bypass Only: Enable

Static-MAB: Disable

Static-MAB Profile: NONE

Tx Period: 30 seconds

Quiet Period: 60 seconds

ReAuth Max: 2

Supplicant Timeout: 30 seconds

Server Timeout: 30 seconds

Re-Auth Interval: 3600 seconds

Max-EAP-Req: 2

Host Mode: SINGLE_HOST

Auth PAE State: Initialize

Backend State: Initialize

Mac-Auth-Bypass: Disable

Mac-Auth-Bypass Only: Disable