Users Guide

• Display the internal statistics for each port-pipe (unit) on per port basis.
show hardware linecard slot—id unit unit-number port-stats [detail]
• Display the line-card internal registers for each port-pipe.
show hardware linecard slot—id unit unit-number register
• Display the tables from the bShell through the CLI without going into the bShell.
show hardware linecard slot—id unit unit-number table-dump {table-name}
• Display hardware statistics from the specified port extender and stack-unit. number {buffer | cpu |
drops| unit}
show hardware pe pe-id stack-unit unit number {buffer | cpu | drops| unit}
• Display the system flow entries on specified port extender and the stack unit in a PE stack. The
command output also displays flow entries on port-set when there are multiple port pipes.
show hardware system-flow pe {PEID stack-unit unit number port-set port-pipe-id counters | <cr>}
• Display FP entries created for layer3 for the PE interface(s) to which the egress ACLs configurations
are applied.
show hardware ip eg-acl pe pe-id stack-unit unit—number port-set number
{ counters | <cr> }
• Display FP entries created for layer3 for the PE interface(s) to which the ingress ACL configurations are
applied.
show hardware ip in-acl pe pe-id stack-unit unit—number port-set number
{ counters | <cr> }
• Display FP entries created for layer 2 for the PE interface(s) to which the egress ACL configurations are
applied.
show hardware mac eg-acl pe pe-id stack-unit unit—number port-set number
{counters | <cr> }
• Display FP entries created for layer 2 for the PE interface(s) to which the ingress ACL configurations
are applied.
show hardware mac in-acl pe pe-id stack-unit unit—number port-set number
{ counters | <cr> }
• Display the registers, counters, drops, buffers, and other details about the Triumph and Switch fabric.
show hardware cp-switch {counters | details | drops | port-stats | register |
table-dump}
show hardware sfm sfm-unit-num {buffer {total-buffer | unit unit-num {port |
total-buffer}} | counters | details | drops | port-stats | register | table-
dump}
• Display hardware system-flow information.
show hardware system-flow stack-unit 0 port-set 0 { counters | }
• Display the system-flow configuration from a specific port extender hardware component.
Show hardware system-flow pe pe—id stack-unit unit—number port-set number
{ counters | }
NOTE: You can also clear the system-flow statistics from the specified port extender hardware
component by using the clear hardware system-flow pe pe—id stack-unit unit—
number port-set number { counters | <cr> } command.
• Display the operational status or the internal ports that are dynamically mapped to a backplane link or
control-plane trunk group that is down.
show hardware {cp | linecard slot—id} bp-link-map
show hardware {cp | linecard slot—id} bp-link-state
352
Debugging and Diagnostics