Users Guide

given port number
psh Match on the psh bit
range Match only packets in the
range of port numbers
rst Match on the rst bit
syn Match on the syn bit
urg Match on the urg bit
cr
Dell(conf-redirect-list)#redirect 1.1.1.1 udp any
any ?
eq Match only packets on a
given port number
gt Match only packets with a
greater port number
lt Match only packets with a
lower port number
neq Match only packets not on a
given port number
range Match only packets in the
range of port numbers
Delete a rule with the no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination
router IP address
The below step shows a step-by-step example of how to create a rule for a redirect list by configuring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information
Creating a Rule Example:
Dell(conf-redirect-list)#redirect ?
A.B.C.D Forwarding router's address
Dell(conf-redirect-list)#redirect 3.3.3.3 ?
<0-255> An IP protocol number
icmp Internet Control Message Protocol
ip Any Internet Protocol
tcp Transmission Control Protocol
udp User Datagram Protocol
Dell(conf-redirect-list)#redirect 3.3.3.3 ip ?
A.B.C.D Source address
any Any source host
host A single source host
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 ?
Mask A.B.C.D or /nn Mask in dotted decimal or in slash
format
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 ?
A.B.C.D Destination address
any Any destination host
host A single destination host
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 ?
Mask A.B.C.D or /nn Mask in dotted decimal or in slash
format
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 /32 ?
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 77.1.1.1 /32
760
Policy-based Routing (PBR)