Users Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

771

772

773

774

775

776

777

778

779

780

Maximum number of PE Units allowed: 40

Current number of PE units in the system: 1

Codes: A - Active, I - Inactive

Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch

SVM - Software Version Mismatch, UE - Unknown Error

Offline Reason: UNP - Unit Not Present,

ICE - IPC CP Error, IRE - IPC RP Error

ISE - IPC Setup Error, CVE - Card Validation Error

PE-ID assigned: 10

Status: online

System Mac: 00:01:02:03:11:01

PE Up Time: 00:02:14

PE Discovery Status: Provisioned PE

User Configured Cascade Ports: Te 1/0(A),Te 1/8(I),Te 1/12(A)

Cascade LAG: Po 268(Up)

---------------------------------------------------------------------

Stack-id Status Reason Type UnitMac No. of Ports

---------------------------------------------------------------------

0 online - C1048P 00:01:02:03:11:01 52

Dell#show pe errors

PE-id: Not Assigned

PE MAC: 00:01:02:03:22:02

Interface Errors:

TenGigabitEthernet 1/8 - Error State

• You may connect a PE to a parent C9010 using both uplink ports but provision the PE with only the

cascade port attached to one of the uplink ports. In this case, the auto-LAG is created with only the

provisioned cascade port when the PE comes online. In the following example, PE 10 is provisioned to

connect only to cascade port 1/12. However, the second uplink port on the PE is also cabled to

cascade port 1/0. As a result, port 1/0 is not included in the auto-LAG although it is discovered as an

LLDP neighbor.

Dell# show running-config pe

feature extended-bridge

pe provision 10

cascade interface TenGigabitEthernet 1/12

stack-unit 0 type C1048P

Dell# show lldp neighbors | grep 00:01:02:03:11:01

Te 1/0 - TenGigabitEthernet 0/1 00:01:02:03:11:01

Te 1/12 - TenGigabitEthernet 0/2 00:01:02:03:11:01

Dell# show pe 10