Users Guide

RIP Configuration Example
The examples in this section show the command sequence to configure RIPv2 on the two routers shown
in the following illustration — Core 2 and Core 3.
The host prompts used in the following example reflect those names. The examples are divided into the
following groups of command sequences:
• Configuring RIPv2 on Core 2
• Core 2 RIP Output
• RIP Configuration on Core 3
• Core 3 RIP Output
• RIP Configuration Summary
Figure 114. RIP Topology Example
RIP Configuration on Core2
The following example shows how to configure RIPv2 on a host named Core2.
Example of Configuring RIPv2 on Core 2
Core2(conf-if-te-2/31)#
Core2(conf-if-te-2/31)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Core 2 RIP Output
The examples in the section show the core 2 RIP output.
Examples of the show ip Command with Core 2 Output
• To display Core 2 RIP database, use the show ip rip database command.
• To display Core 2 RIP setup, use the show ip route command.
• To display Core 2 RIP activity, use the show ip protocols command.
Routing Information Protocol (RIP)
879