Users Guide

LP 3 0 0 85 75 80 70
LP 4 0 0 85 75 80 70
LP 5 0 0 85 75 80 70
LP 6 0 0 85 75 80 70
LP 7 0 0 85 75 80 70
LP 8 0 0 85 75 80 70
LP 9 0 0 85 75 80 70
LP 10 0 0 85 75 80 70
LP 11 0 0 85 75 80 70
PE 0 0 85 75 80 70
Configuring Threshold Memory Utilization for SNMP
Traps
When the total memory utilization for a CPU exceeds the configured high/low threshold for a given time,
a threshold notification is sent as an SNMP trap. If a low threshold value is not specified, the low threshold
value is set to the same value as the high threshold value. Use the util-threshold memory
command to configure the high or low memory utilization threshold for SNMP traps.
Use the util-threshold memory command to configure the high or low memory utilization threshold
for SNMP traps. Use the show util-threshold memory to display the configured values of memory
utilization thresholds.
Parameters
• cp — Enter the keyword cp to configure the memory utilization threshold for the Control Processor
CPU.
• rp — Enter the keyword rp to configure the memory utilization threshold time for the Route
Processor CPU
• lp — Enter the keyword lp to configure the linecard processor memory utilization threshold time. The
range of switch slot IDs is from 0 to 2.
• pe — Enter the keyword, pe to configure the CPU memory utilization time for of all PEs that are
configured in the system.
• all — Enter the keyword all to configure the memory utilization threshold on all switch CPUs:
Control Processor, Route Processor, PE, and line cards.
• {{high | low} cpu-utilization-threshold-percentage} — Enter a percentage value to configure the high
or low threshold level for the percentage of memory a switch CPU can used. The percentage of CPU
use ranges from 0 to 100.
Defaults
– High threshold: 92%
– Low threshold: 82%
NOTE: A threshold level of 0 disables Syslog and SNMP traps.
• Configure the high or low memory utilization thresholds for SNMP traps.
CONFIGURATION mode
util—threshold memory {5 sec | 1 min | 5 min} {cp |rp | lp | pe | all} {high
{0-100} | low {0-100}}
970
Simple Network Management Protocol (SNMP)