Users Guide

53
Storm Control
Storm control allows you to control unknown-unicast, muticast, and broadcast traffic on Layer 2 and
Layer 3 physical interfaces.
Dell Networking Operating System (OS) Behavior: Dell Networking OS supports unknown-unicast,
muticast, and broadcast control (the storm-control broadcast command) for Layer 2 and Layer 3
traffic.
To view the storm control broadcast configuration show storm-control broadcast | multicast
| unknown-unicast | pfc-llfc
[interface] command.
EXEC Privilege
To view the storm control multicast configuration, use the show storm-control broadcast |
multicast | unknown-unicast | pfc-llfc [interface] command.
EXEC Privilege
Example:
Dell#show storm-control multicast Tengigabitethernet 1/1
Multicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------
Te 1/1 Ingress 5
Dell#
To display the storm control unknown-unicast configuration, use the show storm-control unknown-
unicast [interface] command.
EXEC Privilege
Configure Storm Control
Storm control is supported in INTERFACE mode and CONFIGURATION mode.
Configuring Storm Control from INTERFACE Mode
To configure storm control, use the following command.
From INTERFACE mode:
• You can only configure storm control for ingress traffic.
• If you configure storm control from both INTERFACE and CONFIGURATION mode, the INTERFACE
mode configurations override the CONFIGURATION mode configurations.
990
Storm Control