White Papers

• ipv6 nd max-ra-interval — Set IPv6 Max Router Advertisement Interval
• ipv6 nd mtu — Congure MTU advertisements in RA packets
• ipv6 nd other-config-flag — Hosts should use DHCP for non-address cong
• ipv6 nd prefix — Congure IPv6 Routing Prex Advertisement
• ipv6 nd ra-guard — Congure IPv6 ra-guard
• ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
• ipv6 nd reachable-time — Set advertised reachability time
• ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
• ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
• ipv6 ad <ipv6-address> — IPv6 Address Detection
• ipv6 ad autoconfig — IPv6 stateless auto-conguration
• ipv6 address <ipv6-address> — Congure IPv6 address on an interface
NOTE: The command line help still displays relevant details corresponding to each of these commands. However, these interface
range or interface group commands are not supported when Management VRF is congured.
Conguring a Static Route
To congure a static route, perform the following steps:
Table 122. Conguring a Static Route
Task Command Syntax Command Mode
Congure a static route that points to a
management interface.
management route ip-address
mask managementethernet
ormanagement route ipv6-address
prefix-length
managementethernet
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
CONFIGURATION
To congure a static entry in the IPv6 neighbor discovery, perform the following steps:
Table 123.
Conguring a Static Entry in the IPv6 Neighbor Discovery
Task Command Syntax Command Mode
Congure a static neighbor. CONFIGURATION
Route Leaking VRFs
Static routes can be used to redistribute routes between non-default to default/non-default VRF and vice-versa.
NOTE
: Route leaking VRFs are supported only for IPv4 routes.
You can congure route leaking between two VRFs using the following command: ip route vrf x.x.x.x s.s.s.s
nh.nh.nh.nh vrf default.
1058
Virtual Routing and Forwarding (VRF)