White Papers

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied
Save the Running-Conguration
The running-conguration contains the current system conguration. Dell Networking recommends coping your running-conguration to
the startup-conguration.
The system uses the startup-conguration during boot-up to congure the system. The startup-conguration is stored in the internal ash
on the system by default, but it can be saved on a USB ash device or a remote server.
The commands in this section follow the same format as those commands in the Copy Files to and from the System section but use the
lenames startup-conguration and running-conguration. These commands assume that current directory is the internal ash, which is
the system default.
• Save the running-conguration to the startup-conguration on the system.
EXEC Privilege mode
copy running-config startup-config
• Save the running-conguration to an FTP server.
EXEC Privilege mode
copy running-config ftp:// username:password@{hostip | hostname}/filepath/ filename
• Save the running-conguration to a TFTP server.
EXEC Privilege mode
copy running-config tftp://{hostip | hostname}/ filepath/filename
• Save the running-conguration to an SCP server.
EXEC Privilege mode
copy running-config scp://{hostip | hostname}/ filepath/filename
NOTE
: When copying to a server, a host name can only be used if a DNS server is
congured.
NOTE: When you load the startup conguration or a conguration le from a network server such as TFTP to the running
conguration, the conguration is added to the running conguration. This does not replace the existing running conguration.
Commands in the conguration le has precedence over commands in the running conguration.
Congure the Overload Bit for a Startup Scenario
For information about setting the router overload bit for a specic period of time after a switch reload is implemented, refer to the
Intermediate System to Intermediate System (IS-IS) section in the Dell Networking OS Command Line Reference Guide.
Viewing Files
You can only view le information and content on local le systems.
To view a list of les or the contents of a le, use the following commands.
• View a list of les on the internal ash.
EXEC Privilege mode
dir flash:
• View the contents of a le in the internal ash.
EXEC Privilege mode
Getting Started
55