Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R750xs Installation and Service Manual
- Contents
- About this document
- PowerEdge R750xs system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Optional optical drive
- Air shroud
- Cooling fans
- Side wall brackets
- Intrusion switch module
- Optional serial COM port
- Drives
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional IDSDM module
- MicroSD card
- Optional BOSS S2 card
- PERC
- Rear drive module
- Optional OCP card
- System battery
- Optional internal USB card
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Expansion card installation guidelines
Figure 77. Expansion card slot connectors
1. SIG_PWR_0 (Riser power cable for Riser 1A and Riser 1B)
2. SL6_CPU2_PB3 (PCIe cable connector for Riser 1A and Riser 1B)
3. SL5_CP2_PA1 (PCIe cable connector for Riser 1B )
4. SL7_CPU1_PA4 (PCIe cable connector for Riser 1A and Riser 1B)
5. SL8_CPU1_PB4 (PCIe cable connector for Riser 1A and Riser 1B)
The following table describes the expansion card riser configurations:
Table 28. Expansion card riser configurations
Configuratio
ns
Expansion
card risers
PCIe Slots Controlling
processor
Height Length Slot width Power
Config0. R1A 3 Processor 1 Low profile Half length x16 75 W
4 Processor 2 Low profile Half length x16 75 W
Config1. R1B 3 Processor 1
and 2
Low profile Half length x16 75 W
4 Processor 1 Low profile Half length x8 75 W
Config2. R1B 3 Processor 1
and 2
Low profile Half length x16 75 W
4 Processor 1 Low profile Half length x8 75 W
Config3. R1A 3 Processor 1 Low profile Half length x16 75 W
4 Processor 2 Low profile Half length x16 75 W
Config4. NA NA NA NA NA NA NA
82 Installing and removing system components