Users Guide

NOTE: You must have Chassis Configuration Administrator privilege to set up CMC network settings.

Viewing and Modifying CMC Network LAN Settings Using CMC Web Interface

To view and modify the CMC LAN network settings using CMC Web interface:

1. In the left pane, click Chassis Overview, and then click Network. The Network Configuration page displays the

current network settings.

2. Modify the general, IPv4, or IPv6 settings as required. For more information, see the

Online Help

3. Click Apply Changes for each section to apply the settings.

Viewing and Modifying CMC Network LAN Settings Using RACADM

To view IPv4 settings, use the following subcommands and objects:

• getniccfg

• getconfig

• cfgCurrentLanNetworking

To view IPv6 settings, use the following subcommands and objects:

• getconfig

• cfgIpv6LanNetworking

To view IPv4 and IPv6 addressing information for the chassis, use the getsysinfo subcommand.

For more information about the subcommands and objects, see the

Chassis Management Controller for PowerEdge

VRTX RACADM Command Line Reference Guide

Enabling the CMC Network Interface

To enable or disable the CMC network interface for both IPv4 and IPv6, type:

racadm config -g cfgLanNetworking -o cfgNicEnable 1

racadm config -g cfgLanNetworking -o cfgNicEnable 0

NOTE: The CMC NIC is enabled by default.

To enable or disable the CMC IPv4 addressing, type:

racadm config -g cfgLanNetworking -o cfgNicIPv4Enable

NOTE: The CMC IPv4 addressing is enabled by default.

To enable or disable the CMC IPv6 addressing, type:

racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable

NOTE: The CMC IPv6 addressing is disabled by default.