Command Line Reference Guide

• racadm setled -m server-9 -1 1

ERROR: Server in slot 9 is an extension of the server in slot 1.

setniccfg

Description Sets the iDRAC IP address. It displays an error message if the requested operation

could not be performed, or a success message, if the operation is completed

successfully.

To use this subcommand, you must have the Configure iDRAC permission.

NOTE: The terms NIC and Ethernet management port may be used interchangeably.

Synopsis

• racadm setniccfg -d

• racadm setniccfg -d6

• racadm setniccfg -s <IPv4Address> <netmask> <IPv4

gateway>

• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix

Length> <IPv6 Gateway>

• racadm setniccfg -o

Input

• -d — Enables DHCP for the NIC (default is “DHCP disabled”.)

• -d6 — Enables AutoConfig for the NIC. It is enabled by default.

• -s — Enables static IP settings. The IPv4 address, netmask, and gateway can

be specified. Otherwise, the existing static settings are used. <

IPv4Address

netmask

>, and <

gateway

> must be typed as dot-separated strings.

racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• -s6 — Enables static IPv6 settings. The IPv6 address, Prefix Length, and the

IPv6 gateway can be specified.

• -o — Enable or disable NIC.

Example

• racadm setniccfg -s 192.168.0.120 255.255.255.0

192.168.0.1

• racadm setniccfg -d

• racadm setniccfg -d6

setpciecfg

Description Configure PCIe slots and Virtual Adapters.

NOTE: To use this subcommand, you must have Chassis Administrator privilege.

NOTE: The slot assignment feature is licensed.

Synopsis

racadm setpciecfg assign [-c <FQDD>] [-i <server slot>]

racadm setpciecfg unassign [-c <FQDD>]

Input

• -c — Use this option to specify a PCIe adapter or Virtual Adapter.

• -I — Use this option to specify the slot number.